NR RACING

FREE SHIPPING ON ORDERS OVER $300

Click for details

 

 

GX200 RACE MOTORS

MOTORS SOLD FOR ORGANIZED COMPETITION PURPOSES OR EXPORT ONLY

(NOT FOR USE ON ANY EQUIPMENT, OFF ROAD, RECREATIONAL, OR EMISSIONS CONTROLLED

APPLICATIONS. DOING SO IS A VIOLATION OF FEDERAL LAW)

Stock & Blueprinted Engines                      ASN Motors                       Super Stock Series      

Modified (Outlaw) Series Motors                      F200 Motors                                        Options          

Prices are for QX Style Motors. See Options Below for HX2, QMA, RH2, Gearbox, Half Midget, and  Clutch Motors.

Unless stated, Motors do not include tank, muffler, or linkage. If needed select option at bottom of page

ALL MOTORS ARE ALSO AVAILABLE AS EITHER GX160s or GX200s - For GX160s click here

 

STOCK & BLUEPRINTED MOTORS

 

Factory Stock

GX200 Race prepped including,

  • Open Element Air Filter Assembly,

  • Pressure tested 3 angle valve job,

  • removal of governor,

  • 18 lb Valve Springs,

  • Small fan,

  • Advanced Timing,

  • Rejetted carb,

  • Approx 9.0 HP

May be used for ASN, UK, and other Karting classes, however please specify when ordering so we can make sure it is legal for class.

Available as a "Ready to go" Motor - Same as above but includes Cone style Air Filter,  Linkage,  Header/exhaust pipe, throttle cable, and fuel pump mounting plate (Note: If ordered with Gas Tank, fuel pump mounting plate is not included)

Available Options

  • CL1 Dyno Cam - Installed

  • Set up for Methanol

  • ARC Billet Rod, Installed

  • Dyno test engine

  • Aluminum Flywheel

  • Fuel Pump package, includes pulse fitting, Mikuni fuel pump, and hoses, installed.

  • Factory Gas Tank

Approx 9 to 10 hp

GX200 Factory Stock Package

 Select Options below and click button to add to shopping cart

Select Fuel Type

Factory Stock - Gas  $399

  Factory Stock - Methanol $429

 

 

Add Ready to go Package, Adds Kart Header, Linkage, & Air Filter

  None $0

Ready to Go (Kart) +$59

Ready to Go Package - Mini Bike +$69

 

Options

 

Add Aluminum Flywheel $100

Add CL1 Cam $25

Add Billet Rod & Dyno $100

Add Fuel Pump package $35

Sealed Motor (NR Lead Seals Call for details) cover) $10

Blueprint Package (Call for details  $200

Add Gas Tank $20

Add Small Gas Tank & Low Profile Gas Cap (mini bike) $35

Extended Starter nut for hand held starter (no recoil)

 

 

Total Cost        

ASN Motors

IN STOCK AND READY TO SHIP

Our Factory stock specially for ASN racing. "Blueprinted" Motor is completely disassembled, inspected, parts replaced if needed, and reassembled with special attention to insure maximum performance.

 

Special attention is paid to the crankshaft, head, and cam specs/timing. Carb is replaced with Japanese version, and is flowed and all external settings adjusted to produce best power. 

 

Combustion Chamber is set (minimized) to ASN CC requirements.  ASN legal jet and E-Tube added.

 

Most HP & Torque possible for a legal ASN motor. Includes air filter adapter, fuel pump pulse fitting, Fuel Pump Mounting Plate,  and NR Billet linkage, and recoil. (for160s, click here)

 

$899.00

 

 

MODIFIED RACING MOTORS

WARNING: TO PREVENT SERIOUS INJURY AN ALUMINUM FLYWHEEL SHOULD BE USED ON ALL MODIFIED MOTORS.

 

Super Stock

GX200 Super Stock Package

 

Same as Factory Stock but adds

  • Race prepped & milled Head,

  • Bored carb,

  • Valve Cover w/nipple, 

  • 1.3 Rockers Arms,

  • 9.1 to 1 compression 

  • Approx 11 + HP 

Available Options

  • CL1 Dyno Cam

  • 252 Cam packages (w/ upgraded valve train)

  • Set up for Methanol

  • ARC Billet Rod, Installed (RECOMMENDED)

  • Dyno test engine

  • Aluminum Flywheel

  • Fuel Pump package, includes pulse fitting, Mikuni fuel pump, and hoses, installed.

  • Factory Gas Tank

Note: Billet Rod is recommended. We will not dyno engine, or install 252 Cams unless rod is selected.

Select Options below and click button to add to shopping cart

Select Fuel Type

Super Stock  - Gas  $499

  Super Stock  - Methanol $529

 

 

Add Ready to go Package, Adds Kart Header, Linkage, & Air Filter

  None $0

Ready to Go (Kart) +$59

Ready to Go Package - Mini Bike +$69

 

Cam Packages  (Billet rod recommend with all cams other than stock(

  Stock Cam $0

Mod 2 Cam +$50

230 Marine Cam +$50

252 02XX Cam (High Torque) +$159

252 0607 Cam (High HP, Karts, Oval Tracks) +$159

252 0611 Cam (Road Racing, Mini-Bikes) +$159

(252 Cams includes 26lb springs, Chrome Moly Pushrods, Reinforced Rockers, Billet Guide Plate) +

 

Options
Add Billet Rod & Dyno $100 RECOMMENDED

Add Aluminum Flywheel $100

10.5 to 1 Compression $25

Add Fuel Pump package $35

Add Large Gas Tank $20

Add Small Gas Tank & Low Profile Gas Cap (mini bike) $35

Extended Starter nut for hand held starter (no recoil)

 

 

Total Cost        

Limited Mod

 

GX200 Limited Mod Package

 

GX200 Race Motor with

  • Full ported head

  • Stainless Steel valves

  • Oversize intake (27mm)

  • Aluminum Retainers &, Split Keepers

  • Billet rod (long rod available)

  • Stud kit

  • Upgraded C3 Case Bearings,

  • 26 or 30 lb valve springs,

  • Billet Rocker Arms

  • CM pushrods,

  • Billet Guide Plate

  • Race Prepped Block

  • 252 or 274 cam. 

  • Choice of Carbs.

  • Timing Key

  • Air Filter

  • Compression ratios up 12.5 to 1.

  • Dyno Tested (Note: methanol motors will be dyno'd on gas)

  • 12 to 18 hp depending Carb and Cam

 

Select Options below and click button to add to shopping cart
 

Select Engine & Fuel Type

Limited Mod

      Gas  $999

       

Limited Mod 

      Methanol $1029

 

Add Ready to go Package,

Adds Kart Header, Linkage, & Air Filter

  None $0

Ready to Go - Kart $59

Ready to Go - Mini Bike $69

 

Select Carburetor

  .625 Honda $0

SA Extreme (1 to 2 hp) $70

22mm Mikuni  $70

       Gas Only  (~2 hp)

GX390  (~2 hp) $70

24 Mikuni FS  $160

       Gas Only  (~2+ hp)

28 Mikuni FS $170

       Alky Only  (~3+ hp)

Tillotson 304  (~2+ hp) +$40

 

Misc Options
Balance Motor (mallory) $150

Add Fuel Pump package $35

Add Roller Rockers $100

Extended Starter nut for hand held starter (no recoil). Required on .175 strokers

Add Gas Tank $20

 

 

 

Select Compression ratio

  9 to 1

10.5 to 1

11 to 1

12 to 1 (+$25)

13 to 1 (+$75)

 

Camshaft Options

252 0207  (very small tracks)

252 0611  (All Around, Mini-Bikes)

274 0207 (big dirt tracks, Mini-Bikes)

274 0607 (Large paved oval)

   other cams available at no charge

 

Select Flywheel

  OEM $0

Aluminum $90

Small Diameter (Super Light) $170

PLV System w/aluminum flywheel

        (adds ~1 hp) $130

 

Rod/Crank/Stroker Options

  +.020 Rod, T3"

  Long Rod Kit (+~1hp) $225

.060 Stroker Kit (Balanced) $300 

.175 Billet Stroker Kit $550

  (see note on page bottom)

 

Total Cost        

F200 PACKAGE        

GX200 F200 Package

 

Similar to our Limited Modified but with special Porting and Cam/Rocker Arms for F200 Class. 24cc Chamber Volume,  ARC Flywheel, & "built" F200 Tillotson Dominator Carb (Some Tuning may be required) Motor is Dyno'd before shipping - call for specs

 

Includes Linkage, Fuel Pump, and Fuel Pump Mounting Plate.

 

 

Select Options below and click button to add to shopping cart

Select Fuel Type

F200 - Gas  $1549

  

 

Options
Add F200 Exhaust Kit $110

Small Track Package (for very small or tight tracks. Includes special cam for getting off thee corners)

 

Total Cost        

SUPER MODIFIED        

GX200 Super Modified Package

 

Same as Limited Mod but adds

  • Long Rod with Wiseco Piston,

  • 28.5mm Intake/25 Exhaust on 18cc Head

  • ABEC 5 Bearings (When available)

  • Roller Rockers,

  • 24 or 28mm Mikuni

  • 307 Cam

  • Dual Springs

  • Super Light Small Diameter Flywheel

  • Approx 18 to 20 + HP 

  • Has extended nut for handheld starter (no recoil) and compression release removed

  •  

    Select Options below and click button to add to shopping cart

    Select Fuel Type

    Super Mod - Gas (24mm) $1799

      Super Mod - Methanol (28mm) $1799

     

     

    Options
    Add PLV Ignition $75

    Add .175 Stroker Kit $400

     

    Total Cost        

    Options - Charging and Lighting 

    Available on all motors, but not available with Aluminun Flywheels

    Battery Charging Package 1A,  

    Single Coil capable of 1A (12 watt). Will maintain battery, but not capable of running lights. Includes 1A Coil and Flywheel

    $150

    Lighting Package 50W,  

    Dual Coil capable of 50W at 12V. Will run most small Snow Mobile and ATV headlights, but may not be able of keeping up demands depending on accessories installed. Includes 50W Coil and Flywheel

    $220

    High Output Lighting Package 84W. Use for running headlights and accessories. Use when maximum lighting and charging is needed. Includes 84W Coil and Flywheel. Requires rectifier, not included

    $290

    Options - Gear Boxes

    HX2 6 to 1 Gear Box Installed

     

    $210

    QMA Half Midget Prepped HX2 w/ 6 to 1 Gear Box (Rotate Gear Box, Remove Fuel tank Bosses, Remove recoil, & Shorten Starter Cup)

     

    $210

    RH2 2 to 1 Gear Box with Clutch installed

     

    $200

    Options - Electric Start

    Electric Start Option (adds electric starter with key switch), GX200s. Not available with aluminum flywheels.

     

    $240

    Options - Misc

    Stock GX200 Muffler, Installed

     

    $10

    Stock Air Cleaner and Linkage Assembly, Installed

     

    $0

    Email to request this Option

    Lead time on motors ranges from 1 to 3 days for a Package 1 to around 4 weeks all out race motors.  We do keep some engines on the shelf and ship as quick as we can, However, this is dependent on time of year. Expect longer lead times before and during race season

    .175 Stroker Package requires removal of Compression release and must be started using hand held electric starter. Motor is shipped with extended starter nut and aluminum fan cover (no recoil)